6
6
WINE CELLAR USE
Normal Sounds
Your new wine cellar may make sounds that your old one didn’t
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
■
Your wine cellar is designed to run more efficiently to keep
your wine at the desired temperatures and to minimize energy
usage. The high efficiency compressor and fans may cause
your wine cellar to run longer than your old one. You may also
hear a pulsating or high-pitched sound from the compressor
or fans adjusting to optimize performance.
■
Rattling noises may come from the flow of refrigerant or items
stored inside the wine cellar.
■
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your wine cellar.
■
You may hear water running into the drain pan when the wine
cellar is defrosting.
■
You may hear clicking sounds when the wine cellar starts or
stops running.
Using the Controls
The control panel for the wine cellar is located on the middle
separator (mullion) of the wine cellar. The control of the wine
cellar has no mechanical parts or buttons. When disconnected,
the control panel displays nothing and may be difficult to locate.
Turning Control On/Off
■
The first time that the wine cellar is plugged in, the control will
be in Cool Off mode. Cool On and Cool Off will be the only
options that display.
■
Press COOL ON for 3 seconds to turn on the wine cellar. All
menus and recommended temperature settings will be
displayed.
■
The left temperature and preset touch pads control the
temperature of the upper compartment.
■
The right temperature and preset touch pads control the
temperature of the lower compartment.
Viewing Celsius Temperatures
■
Press the F/C touch pad to toggle between displaying the
temperature in degrees Fahrenheit and degrees Celsius. The
corresponding indicator will illuminate.
Adjusting the Control
When the wine cellar is turned On for the first time, the
temperature defaults to the recommended setting. There are two
adjustable temperature controls, with one for each compartment.
■
To adjust set point temperatures, press “+” (plus) or “-”
(minus) until the desired temperature setting is reached.
NOTE: The set point for the wine cellar is 50°F (10°C) for both the
upper and lower compartments. The set point range for the
upper compartment is 42°F to 54°F (5°C to 12°C) and 42°F to
64°F (5°C to 17°C) for the lower compartment
The control is set correctly when the wine is as cold as you like it.
NOTE: Wait at least 24 hours between adjustments for the
product to acclimate. Recheck the temperatures before making
further adjustments.
A. F/C touch pad
A
