5
Parts supplied
Remove parts from packages. Check that all parts are included.
■
2 metal grease filters for 30" (76.2 cm) models
3 metal grease filters for 36" (91.4 cm) models
3 metal grease filters for 42" (106.7 cm) models
4 metal grease filters for 48" (121.9 cm) models
■
2 mounting brackets with adjustment screws installed
■
2 mounting bracket screws
■
4 washer head Phillips mounting screws
■
Damper
■
2 dampers for 48" (121.9 cm) model.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Have a qualified technician install the range hood. It is the
installer's responsibility to comply with installation clearances
specified on the model/serial rating plate. The model/serial rating
plate is located inside the range hood on the rear wall of the
range hood.
Canopy range hood location should be away from strong draft
areas, such as windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used. Given
dimensions provide minimum clearance.
The canopy range hood is factory set for venting through the roof
or through the wall.
All openings in ceiling and wall where canopy range hood will be
installed must be sealed.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local
codes.
Product Dimensions
Vented Installations
Optional Full-Width Duct Cover Installations
Optional Telescopic Chimney Kit Installations
25" (63.5 cm)
18" (45.7 cm)
12" (30.5 cm)
30" (76.2 cm),
36" (91.4 cm),
42" (106.7 cm) or
48" (121.9 cm)
12"
(30.5 cm)
18"
(45.7 cm)
12"
(30.5 cm)
12"- 23"
(30.5 cm - 58.4 cm)
12"
(30.5 cm)
24 "
(63.2 cm)
11
⁷⁄₁₆
"
(29.0 cm)
⁷⁄₈
