11
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors and
odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the kitchen.
The range hood controls are located on the front side of the canopy.
Control Panel
Display
Grease Filter Saturation Alarm
After 30 hours of fan operation, the display will show “Clean
Grease Filter” when the fan is active. When this icon shows in the
display, the installed grease filters should be washed. See
“Range Hood Care” section.
■
To reset the grease filter saturation alarm, press and hold the
POWER INCREASE button for 5 seconds. The “Clean Grease
Filter” icon will no longer be displayed.
Charcoal Filter Saturation Alarm
After 120 hours of fan operation, the display will show “Replace
Charcoal Filter” when the fan is active. When this icon shows in
the display, the charcoal filters should be replaced. See “Range
Hood Care” section.
■
To reset the charcoal filter saturation alarm, press and hold
the POWER DECREASE button for 5 seconds. The “Replace
Charcoal Filter” icon will no longer be displayed.
Audible Signal Activation and Deactivation
The audible signal can be activated or deactivated by pressing
the Light button for 5 seconds.
■
If the audible signal is activated, a tone will sound, and “Snd”
symbol will appear in the display for 3 seconds.
■
If the audible signal is deactivated, the “Snd” symbol will
appear on the display for 3 seconds. A tone will not sound.
Charcoal Filter (Recirculation Accessory) Inclusion and
Exclusion
When the charcoal filter is in use (recirculating mode), press and
hold the POWER DECREASE and POWER INCREASE buttons at
the same time for 5 seconds. “Able” will appear in the display for
3 seconds.
If the charcoal filter is not used (vented mode), press and hold the
POWER DECREASE and POWER INCREASE buttons at the
same time for 5 seconds. “None” will appear in the display for
3 seconds.
■
When the charcoal filter has been excluded, the charcoal filter
alarm is disabled.
■
The inclusion or exclusion of the charcoal filter must be
selected while the lights and the fan motor are Off.
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. Lamp housings
D. Canopy
E. Grease filters
F. Grease filter handles
G. Control panel
A. Power decrease
B. Power increase
C. Display
D. Light
E. Timer
A
B
C
D
E
F
G
A
B
C
D
E
