12
Heat Sensor
The control is equipped with a heat sensor that will turn on the
blower to the highest speed if excessive heat occurs around the
control area.
■
If the blower is On or Off, the blower will automatically set to
the highest speed. “Auto” will appear in the display to
indicate that the heat sensor has detected excessive heat.
■
When the blower is operating due to excessive heat detected
by the heat sensor, the blower speed cannot be decreased.
■
When the temperature level on the hood drops to normal, the
blower will return to its setting before the excessive heat was
sensed.
Light
To operate the light:
1. Press the Light button to turn the light on to High.
2. Press the Light button again to turn the light to Low.
3. Press the Light button a third time to turn the light Off.
Timer
The timer can be set from 1 to 60 minutes. The default timer
setting is 10 minutes.
To use the timer:
1. Press the Timer button to enter the timer mode. After
5 seconds, the default time will be automatically selected.
2. Press the POWER DECREASE and POWER INCREASE
buttons while the display is flashing (5 seconds) to adjust to
the desired time. Pressing the timer button again or waiting
5 seconds after selecting the desired time will start the timer
countdown.
3. The timer can be canceled at any time by pressing the Timer
button again.
NOTE: During the timer setup, the Power Decrease and Power
Increase buttons are dedicated to the timer. After the timer starts,
the Power Decrease and Power Increase buttons can be used for
other functions.
Fan Speed
Power Increase/On
This button is used to turn On the fan or increase the fan speed.
■
The fan will turn On if the Power Increase button is pressed
and the hood was Off.
■
An audible tone will sound when the fan reaches its highest
speed.
Power Decrease/Off
■
This button is used to turn Off the fan or to decrease the fan
speed.
Timed Fan Off
The control has a “Timed Fan Off” feature. When activated, it
automatically turns Off the blower fan after 10 minutes.
■
Press and hold the TIMER button for 5 seconds to activate.
The fan icon will flash and “10:00” (ten minutes) will show in
the display. The time will start counting down after 3 seconds.
