6
To Adjust
1.
Light burner using information from the “Outdoor Grill Use”
section in the Use and Care Guide.
2.
Observe flame to determine which burners need adjustment
and how the flame is acting. See “Burner Flame
Characteristics” above.
3.
Turn off the valve and wait until grill and burners cool
completely.
4.
Remove grill grates and sear plates.
5.
Remove the 2 screws that hold the burner in place. Remove
gas burner from the grill.
6.
If flame is yellow (not enough air), turn air shutter adjustment
screw counterclockwise.
If flame is noisy or lifts away from burner (too much air), turn
air shutter adjustment screw clockwise.
Adjustment should be made clockwise or counterclockwise
from
¹⁄₈
" (3.2 mm) to
¹⁄₄
" (6.4 mm).
7.
Replace gas burner, sear plates and grates.
8.
Light burner using information from the “Outdoor Grill Use”
section in the Use and Care Guide. See “Burner Flame
Characteristics.”
Low Flame Adjustment
If flame goes out on the “LO” setting, the low flame setting must
be adjusted.
1.
Turn off the valve and wait until grill and burners are cool.
2.
Remove grill grates and sear plates.
3.
Light grill using information from the “Outdoor Grill Use”
section in the Use and Care Guide.
4.
Turn burner to its lowest setting and remove knob.
5.
Hold valve stem with pliers and insert a thin flat-blade
screwdriver into the shaft.
6.
Watch the flame and slowly turn the screwdriver
counterclockwise.
7.
Adjust flame to minimum stable flame.
8.
Replace the control knob and turn off the burner.
9.
Repeat steps 3 through 8 for each burner if needed.
10.
Replace the sear plates and grates after the burners have
cooled.
Replace parts and record conversion
1.
Allow the burners to cool down.
2.
Replace sear plates, grates, rear cover, and access cover.
3.
The appliance nameplate is located inside the grill cabinet on
the right-hand cabinet side. With a permanent marker, check
the box next to “Natural gas” and mark through “LP –
Propane.”
In the last page of the owners manual, write “Converted to
Natural Gas.” Also record the conversion date and the
technician/company that performed the conversion.
A. Two screws
A. Air shutter adjustment screw
A
A
A. Valve stem
B. Flat-blade screwdriver
C. Pliers
A
B
C
