TO RAISE BOWL
• Rotate handle back and up until it snaps
into the locked vertical position.
• Bowl must always be in raised, locked
position when mixing.
TO LOWER BOWL
• Rotate handle back and down.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Lower bowl by rotating bowl lift handle
downward.
• Slip flat beater on beater shaft and press
upward as far as possible.
• Turn beater to right, hooking beater over the
pin on shaft.
TO REMOVE FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Lower bowl by rotating bowl lift handle
downward.
• Press beater upward as far as possible and
turn left.
• Pull beater from beater shaft.
TO OPERATE SPEED CONTROL
• Speed control lever should always be set on
lowest speed for starting, then gradually
moved to desired higher speed to avoid
splashing ingredients out of bowl. See
“Speed Control Guide.”
OVERLOAD RESET BUTTON
(Model 5KPM50 only)
• If the mixer is overloaded, the Overload
Reset Button will pop out and the mixer will
shut off. Turn the Speed Control Lever to
OFF. Wait a few minutes, then push in the
Overload Reset Button. Turn the Speed
Control Lever to the desired speed and
continue mixing.
E
n
g
li
sh
7
TO ATTACH BOWL
• Be sure speed control is OFF.
• Place bowl lift handle in down position.
• Fit bowl supports over locating pins.
• Press down on back of bowl until bowl pin
snaps into spring latch.
• Sit pouring shield* on bowl.
• Raise bowl before mixing.
TO ATTACH POURING SHIELD*
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect power.
3. Attach Flat Beater, Dough Hook, or Wire
Whip and bowl.
4. From the front of the mixer, slide the Pouring
Shield over the bowl until the shield is
centered. The bottom rim of the shield
should fit within the bowl.
TO REMOVE POURING SHIELD
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect power.
3. Lift the front of the Pouring Shield clear
of the bowl rim and pull forward.
4. Remove attachment and bowl.
TO USE POURING SHIELD
1. For best results, rotate the shield so the
motor head covers the “u” shaped gap in
the shield. The pouring chute will be just to
the right of the attachment hub as you face
the mixer.
2. Pour the ingredients into the bowl through
the pouring chute.
* If Pouring Shield is included
NOTE:
Check that bowl and pouring shield are
properly in place.
TO REMOVE BOWL
• Place bowl lift handle in down position.
• Grasp bowl handle and lift straight up and
off locating pins.
0 1 2 4 6 8 10
