User Manual KiweeOne
18
6.5.c Setting the output voltage
6.5 Using the electricity
6.5.a Connections
WARNING : KiweeOne will
NOT check the device if it is
not a battery. Plugging a
12V device while the box is
on 24V will damage the
device.
The terminal block and the
cigarette lighter outlet
work in parallel. Once a
device is powered by one of
these two outlets, security
is turned off on the second
one. This can create a risk
in the case of a bad
connection.
6.5.b Internal battery charge rate
KiweeOne smartly manages the charge rate of it’s internal
battery in order to keep enough energy for automatic reel
out and reel in. :
•
Under 40%, the cigarette lighter outlet and the
terminal block are turned off.
•
Under 30%, all outlets are turned off.
The battery charges when the wind turbine is operating. You
can also charge with the charge socket using a 10S 42V/2A
charger and Jack 5.5*2.1 connector (not provided with the
KiweeOne).
Connection types available on the box are described p7.
KiweeOne automatically detects when a device is plugged on
one of its outlets. The electronic box then checks if it is
possible to power the device. KiweeOne will NOT power the
device :
•
If the device is a 12V Battery and the box is set on 24V
mode.
•
If the device is a 24V Battery and the box is set on 12V
mode.
•
If the device is a battery and was plugged on the
wrong polarity (only on the terminal block and the
cigarette lighter outlet).
WARNING:
Stay alert and always
check by yourself the
compatibility
before
plugging in your devices.
Factory setup of the electrical box is 12V. To set
it to 24V, open the box (4 cruciform screws) and
move the connector circled in the left picture to
the position shown below. Kitewinder is not
responsible for any damage made to your
equipment as a result of improper handling .
+12V
+24V
+12V
+24V
Connector in
12V Mode
Connector in
24V Mode
