16
2) Insert the plugs (8P) of the relay cable for operation into the sockets (8P) of each of 2
hoists, and securely tighten the lock rings.
1) Insert the plugs (4P) of the relay cable for power into the sockets (4P) of each of 2 hoists,
and securely tighten the lock rings.
Connecting the relay cable
●
2) Insert the cord chain stopper into the end ring of the protection wire, and fix the stopper to
the socket holder with a pan head screw.
1) Insert the plug (8P) of the push button swtich cord into the socket (8P), and securely tighten the
lock ring.
Connecting the push button switch cord
●
2) Remove the cable packing from the power cable, and pass holder A through the power
cable.
1) Remove holder A installed on the connection box.
Connecting the power cable
●
3) Pass the cable packing through the power cable (see the figure P15), and then insert it
into the connection box.
4) Tighten holder A, and fix the power cable to the connection box.
5) Connect the power cable to the terminal panel in the connection box.
(Refer to the wiring diagram on the connection box to perform wiring correctly.)
6) Fix the cable holder on the power cable to the cable holder arm.
Assembling
Connecting Cables
Summary of Contents for ER2-075S
