22
4.3.3
Cord Control - When using a hoist with cord control, pull down on the appropriate colored cord to raise
or lower the hoist. White indicates the raise control and red indicates lowering control. Release the
cords to stop the hoist. Refer to Figure 4-2 below.
Figure 4-2
Cord Control
4.3.4
Make sure the motor completely stops before reversing direction.
4.4
Adjusting the Controls
4.4.1
For pendant control, the speed can be adjusted by the amount the lever is depressed. As shown below
in Figure 4-3, by depressing the lever slightly, you will be able control the hoist’s motions slowly and
with more precision. By depressing the lever further, the speed of the hoist will be increased until the
lever is fully depressed.
4.4.2
For the cord type control, adjust the speed by varying the amount of pull on the cord. Refer to
Figure
4-4.
Figure 4-4
Cord Control Speed Adjustment
Summary of Contents for Harrington TCR
