4
5
Instructions for use
Getting started
To connect the two speakers together
1. Loosen the Binding post terminals (10/11/13/14) on both speakers, as shown in Figure 1
2. Insert the silver half of the speaker cable into the black binding post on the master speaker
3. Insert the copper half of the cable into the red binding post on the master speaker. Tighten both binding posts, as shown in
Figures 2 and 3
4. Insert the other ends of the cable into the matching coloured binding post on the slave speaker, and tighten
Note:
When inserting the cable into the binding posts, ensure the bare wire is in direct contact with the metal part of the binding post.
To connect the speaker to power
1. Insert the power lead into the Mains power port (12)
2. Insert the UK plug into a plug socket (Figure 4)
3. To turn the speakers on, move the Power switch (9) to the on (l) position on the back panel and the Reunion will enter standby
mode, and the LED (1) will be solid red
4. To turn the speakers off, move the Power switch (9) to the off (O) position
Changing the mains power lead (UK/EU)
Your mains power lead can be unscrewed to expose the EU power lead. Please refer to Figure 5/6.
1. Place a screwdriver on the screw on the plug head. Turn the screw until it comes out
2. Now pull the EU lead out from the EU to UK adaptor
To put the EU power lead back into the EU to UK adaptor, do the reverse of the above instructions.
Figure 1
Figure 2
Figure 3
Figure 4: UK mains
Figure 5: Euro plug with UK mains adaptor
Figure 6
