6
7
LED indicator
Function
LED
Power off/Standby
Solid red
Reset
Flashing blue and purple
Wireless pairing mode
Flashing blue
Wireless paired
Solid blue
Aux mode
Flash purple twice
RCA mode
Flash purple once
Button press registered
Flash purple twice, and then indicate mode
Standby mode
To turn on from standby mode, short press Power (A) on the remote and the LED indicator (1) will flash purple on the master speaker
and then enter its most recent mode. To return to standby mode, short press power (A) on the remote and the LED indicator (1)
will be solid red.
Note:
The Reunion will return to the last known input setting when powered on unless a 3.5 mm aux is connected. If so, the speaker will
default to the AUX input.
Replacing battery in remote
1. Remove Battery cover (N) and coin cell battery
2. Place new battery coin cell (CR2025) into battery compartment so that the text on the battery remains visible
3. Replace Battery cover (N)
Using the remote
1. During initial setup of the Reunion, please remove plastic tab from battery compartment before using the remote
2. Ensure the Remote transmitter (B) is pointing directly to the Remote sensor (2) and nothing is blocking its path
Remote controls
Power on
Hold On/Off (A) down for 2 seconds
Power off
Hold On/Off (A) down for 4 seconds
Pair
Press Pair (I) and immediately release
Mute
Press Mute (C) and immediately release
Reset
Press Reset (J) and immediately release
Play/Pause
Press Play/Pause (D) and immediately release
Change Volume
Press /Volume– (F) and immediately release
Change Bass
Press Bass+/Bass– (G) and immediately release
Change Treble
Press /Treble– (H) and immediately release
Bluetooth mode
Press BT mode (M) and immediately release
AUX mode
Press AUX mode (L) and immediately release
RCA mode
Press RCA mode (K) and immediately release
