10
11
Instructions for use
Charging the speaker
It is recommended that you give the speaker a full charge before its first use.
1. Insert the DC port end of the cable into the DC charge port (9)
2. Insert the plug end of the cable into a plug point in your home
3. The LED charging light indicator (8) will turn red during charging
4. When charging is complete, the LED charging light indicator (8)
will turn a solid green
note:
It may take up to 4 hours before the speaker is fully charged.
Pairing the speaker to your device
Before you can use the speaker via Bluetooth, it will need to be paired to your
device. To do this:
1. Press the Power On/Off (4) and the LED light indicator (7) will be quickly
flashing blue
2. The speaker should automatically enter pairing mode
3. Turn your device’s Bluetooth ON and search for new devices
4. When the ‘Soul 2’ appears in the list, select it and if asked for a passcode,
enter ‘0000’
5. The speaker should then be paired to your device
6. Once paired the LED light indicator (7) will be slowly flashing blue
note:
If you disconnect your Bluetooth or are out of range for 10 minutes the
Soul 2 will turn off automatically.
To pair additional devices to the speaker, first make sure the Bluetooth on any
devices that have already been paired to the speaker is turned off. Then follow
the above instructions from step 1.
