4
5
Instructions for use
Warning
For your safety and the safety of others around you, the menu
and setting choices of the camera must not be used whilst
operating a vehicle.
The camera will be setup and ready to use with the optimum
settings for most situations. The camera will switch on and start
recording when the power is connected and switch off when the
power is disconnected. During this time it will record on a loop of
3 minutes and will only save the video clip to the SD card when the
following happens.
•
If you press the Power on/off button (4) once whilst recording
•
There is an accident significant enough to trigger the built-in
G sensor
•
The camera is turned off whilst recording
Note:
you will see a key icon in the top left of the screen to indicate
the video clip has been saved.
Setting up the camera
1. Insert a micro SD card into the Micro SD card input (12) and
connect the camera to your car’s 12 V/24 V cigarette lighter
using the included car charger USB cable with the other end
plugged into the Micro USB input (1).
2. If required, assemble the suction mount by loosening the nut
on the mount. Do not remove it entirely; instead, firmly push the
ball joint adaptor into the socket, and then screw the bolt back
to tighten.
3. Affix the camera to the windscreen using the now assembled
suction mount, being careful not to obstruct your view of the road.
4. When car ignition is turned on, the camera will automatically
start recording. When the car power is turned off the camera
will automatically turn off and the chosen length of video will be
saved to the micro SD card. (default setting 3 minutes)
[continued...]
