FR
EN
32
CHECK AND MAINTENANCE
C11
TINES REPLACEMENT
In case of wear of the extremity of knives and sharp edge, a replacement
by reversal is possible.
Tines (46 all in all) are installed on metallic furniture in two, back to back.
They are fixed with screw (2), washer (3) and nut (4). For the fixing nut
(4), verify the following points:
• At least two screws of bolt go over the end of nut.
• Tines (1) must not be blocked in their supports and keep free.
NOTE:
In case of break or extreme wear, replace tines.
When the abnormal vibration appears, immediately stop working
and move the machine to flat place, then turn off the engine and
check tines .
Before each operation, make sure that the bolts and nuts are well
fixed and tines are not lacked or damaged.
For safety reason, replace the bolts and nuts with new ones when
the replacement of tine or reversing the tine.
1
2
3
4
Stop the engine
and disconnect the
spark plug before
any intervention.
C12
PROTECTION COVER
BEFORE EACH USE VERIFY:
1 - If necessary, replacement of the protection flaps (1). Remove the
pin and the washer situated at the end of the fixing axle.
After the replacement, make sure that the protection cover (2) can
move smoothly to forward and backward.
2 - Clean tine cover
Do not leave grasses or mud inside of tine cover. Grasses or mud in
the tine cover may cause difficult work or excessive load on the
machine.
C13
COOLING SYSTEM
BEFORE EACH USE VERIFY:
When the recoil starter is clogged with grass or dust, the engine will
overheat.
Clean recoil starter cover frequently.
1
2
HAVE THIS WORK DONE BY AN APPROVED REPAIR SHOP
Summary of Contents for MAXIMA
Page 34: ...34 ...
