Kiwi Camping Oasis Shelter, Manual

7.  Unfold canopy and pull over frame. Fold back one 

flap on canopy to allow easy access to inside of 

shelter frame and underside of canopy (Fig. 9).

8.  Locate the hook and loop 

fasteners closest to the 

centre of the underside 

of the canopy and wrap 

around poles to secure 

tightly (Fig. 10).

9.  Position pad feet at the four corners. Unroll 

the webbing straps from the corners and 

connect them to the side release buckles on the 

corresponding corner. This stops the corners 

from ‘splaying’ out 

when the steel poles 

are inserted. Note: 

Pad feet must angle 

toward centre of 

shelter with vertical 

slots facing outward. 

(Fig. 11).

10. Insert ends of poles into 

pad feet and twist until 

metal pin locks into slot 

(Fig. 12).

11. Repeat for other three 

pad feet locations.

12. Drive pegs through 

holes in pad feet 

to secure BEFORE 

proceeding to Step 

13) (Fig. 13).

Note: Two pegs are 

provided per pad 

foot. Additional pegs 

may be required, 

depending on soil 

type.

Complete last part of 

leg pole assembly to 

erect frame.

13. Attach hook end of canopy tension strap to square 

slot on the pad feet. Repeat for the remaining 

three pad feet. Pull down strap, at each corner to 

tighten (Fig. 14 and 15).

14. Wrap web straps around pole at all four corners 

and hook snap-in buckles. Pull strap to tighten 

(Fig. 16 and 17).

15. Attach guy lines to web loops located on outside 

seams of canopy then secure with stakes  

(Fig. 18).

16. Fine tune the canopy so it remains taut and 

positioned correctly over the frame.

17. If required, attach the solid wall to chosen side of 

the shelter.

REVERSE THE PROCEDURE TO LOWER THE SHELTER.

PACKING INSTRUCTIONS

Pack the poles and pegs into their bags. Fold the 

shelter from each side to the centre and in half again. 

Adjust to the length of the poles Place the poles onto 

the floor and roll them inside so that the floor is on 

the outside. Store and pack the shelter in its bag.

Fig. 9

Fig. 10

Fig. 12

Metal

pin in 

slot

Fig. 11

Slots

Angle faces

inward

Fig. 13

Fig. 14

Fig. 15

Fig. 16

Fig. 17

Web Loop

Guy Line

Stake

Fig. 18

Completed Shelter