36
Installation
9.3 Installation procedure
•
Position the suspension plate on the
ceiling, mark the position of the drill
holes and drill the holes according to
the required plugs / screws.
Note:
Use dowels and screws according to
the nature of the ceiling on which the
plate is to be installed.
Ask an installer or qualified technician
which anchor bolts or screws to
choose.
•
Connect the decor panel to the
suspension plate using the 2 x ST4
(8mm) screws.
ST4 x 8
!
9.2 Important information before
installing the appliance:
•
Clean the environment thoroughly
before and after installation so that
no dust or construction debris can be
sucked in during initial operation.
•
Only install the unit in a suitable
location.
• Check the ceiling for load-bearing ca-
pacity: It must be able to bear a weight
of min. 120kg and be min. 30mm thick.
• Check the routing of electrical and
other cables on and in the wall or cei
-
ling so that they are not drilled into.
• Check the condition and load-bearing
capacity of the electrical cables.
!
During and after installation of the appli
-
ance, use a spirit level to ensure that the
cooker hood is level.
Otherwise, grease and/or condensation
may accumulate in the corners of the
appliance.
The installation of the appliance
by a specialist is recommended.
Summary of Contents for Cube
Page 20: ......
Page 21: ...Version 3 0 200403 EN User s manual for your cooker hood Model CUBE PROF I LINE ...
Page 39: ......