10
OPTIONS mode
LCD contrast
EDIT mode
No Edit
Full Edit
dB from Clip
dBu
Volts
VU meter mode
normal fast
peak hold
slow decay
LOCK code
Temperature units
Celsius Fahrenheit
Press the OPTION key to select the OPTIONS menu. The last used option program will appear on the
display. Press SELECT (
or
) keys to scroll through the options. Use the rotary PARAMETER
encoder to adjust each option value/function. The user can leave the OPTION mode by pressing the
OPTION key again, or the user can press any other MODE key (i. e. pressing the EDIT key switch to
Edit mode).
The LCD contrast or viewing angle can be set in a range of -10 (angle down) and +10 (angle up).
By selecting
, the EDIT, SELECT (
or
), STORE and ENTER keys are inoperative
(unless in OPTION menu), but remote program change is possible.
By selecting
, all function blocks and parameter setting are accessible.
This function allows setting the measurement units of the compressor threshold.
. Threshold setting in dB relative to full modulation. (0dB = full
modulation).
. The threshold value is displayed in dBu (0dBu = 0.775V).
. The threshold value is displayed in volts.
. The peak hold function is off; the levels are displayed with a fast decay
rate of approximately 600dB/s.
. The peak hold function is on for a more convenient level setting.
. With this setting, levels are displayed with a longer decay rate of
approximately 60dB/s, i. e. with lower signal levels the meters drop more slowly.
A four digit code which is factory set to 0000. After power on, this display defaults to 0000.
Rotate the rotary PARAMETER encoder to select a lock code value. When this code has been
set (after exit from the OPTION menu), the unit is locked and none of the front panel controls or
parameters can be accessed and adjusted. However, remote programme change is possible.
To unlock, press OPTION key, scroll through the options until LOCK CODE is displayed,
rotate the rotary PARAMETER encoder until the lock code is displayed and then press the
STORE key.
These are the units for the environmental temperature. Options are
or
.
3
3
4
4
! CAUTION ! Do not forget your code number. If the code number is lost, the unit can only be
unlocked after contacting your local Klark Teknik distributor.
COMPRESSOR and Limiter threshold units
