11
Timer Function
• When the machine is on, press the Timer button, the machine will be accumulated in units of 1 hour, and the
indication light will show the status accordingly.
• The timer can be set from 1-24 hours, 0 means without setting timer.
• If the Temperature indicator on, the Temp./Timer indicator will show the temperature currently, press the
Timer button, the temperature indicator off, at the same time, the Timer indicator on, and the Temp./Timer
indicator will show the remaining time of the timer. Press the timer button one more time, then can enter
the Timer setting mode.
• After setting the timer mode, the Temp./Timer indicator will show the setting time about 10 seconds. Then
the Temp./Timer indicator and the Timer indicator will flash 5 times, and back to the temperature display, at
the same time, the Timer indicator off, and the Temperature indicator on.
AUTO Mode Function
• Press the SPEED button choosing circularly, the machine can enter AUTO mode, and the AUTO indicator on.
• The AUTO mode is working automatically according to the air quality.
• When the AUTO mode is on, the Air Quality indicator is on, and shows the air quality good or bad; if the light
is green, it means the air quality is good; if the light is yellow, it means the air quality is not so good; if the
light is red, it means the air quality is bad.
• When the AUTO mode is on, it needs about 1 minute to detect the air quality. After 1 minute, the Air Quality
indicator can show the correct current air quality.
• When the air quality is good, the fan works under LOW-range; when the air quality is medium, the fan works
under MED-range; when the air quality is bad, the fan works under HIGH-range.
Display Light
When the machine is on, after 10 seconds without pressing any buttons, the display turns dark.
Cleaning and Care
• Cut off the power source before the following operation.
• Multi-layer filters must be replaced regularly. And it`s better to replace it
3-6 months.
• If the filter is cleanable, you can use a vacuum cleaner to clean the inlet
surface to make it clean. But after 2 and 3 times cleaning, the filter should
change a new one in case of affecting the effect.
Get Down the Air Inlet Grid
Put the machine flat, use the thumb to press the air inlet grid buckle gently,
and wave out gently. Then the air inlet grid will come out as picture shows.
