10
Circulation
1.
First set up the pump connection pipe.
2. Before switch on the pump, make sure the device had been filled with water.
3. Dry running the pump is forbidden, it will damage the pump if working without water go through.
4. Circulation is not necessary for boiling process. Please do not switch on the pump while the device carry
on boiling.
5. If the pump stop working, it may be blocked by residue. Please switch off the machine and un-plug it.
Make sure there is no liquid in the device, and machine had been cool down, then open the plastic cover.
Take the pump out, un-screw it and remove the residue.
6. The pump should be cleaned after used immediately incase of the wort stay inside of it and get dry.
7. Use luke-warm water to go through it for 5mins after each brewing until you make sure inside is cleaned.
Cleaning and Care
• The device must be cleaned immediately after the brewing process. Avoid surface drying of wort and malt
remnants, as this will significantly impair the cleaning process.
• All stainless steel components can be cleaned using a conventional detergent.
• Abrasive agents and sponges/brushes that cause scratching are not suitable. Ideally use a pipe cleaner th-
read to clean the bottom element part.
• When cleaning the brewing vessel ensure that no water spray or moisture comes into contact with the elec-
trical components. The Plug must be protected for performing cleaning activities.
• Before starting the brewing process, remove all dust and dirt from the device and all internal fitting by me-
ans of warm water. Also rinse the pump and lines by means of transfer pumping.
Caution
: Never run the pump without water.
• The valve also need to be cleaned, all the components like water pipe, cover and false bottom had to be
cleaned, as these could have a negative impact on the foam stability of the beer if with dirt on.
• The device must be sorted in dry location. Avoid contact with ferrous or rusty objects.
Error Codes
E1
Sensor is open circuit.
E2
Sensor is short circuit.
C1
Press "-" and "+" at the same time, for temperature correction. Temperature correction range is from
-10°C to +10°C.
Summary of Contents for 10030551
Page 1: ...10030551 Maischekessel...
