21
EN
Error Codes and Cooling Protection (Electronic Model)
E1
When dumping heater body is greater than or equal to 60 ° or body
overheat protect, it will display El, after put the heater in flat or the
temperature is reduced, you need to reboot the heater, it will restore normal
operation.
E2
The temperature sensor failure, check if the temperature sensor is off, break or
adhesion. L after the removal of faults , you need to reboot the heater to return
to normal operation.
Cooling Protection: even you turn off the heater, the fan and indicator will delay 30
seconds before shutdown, serve to reduce the internal temperature to protect electronics.
Mechanical Model
NOTE: For first time operation.there will have some smell.because this Heater have
some protective oil on the surface of the heating element during production.
1 Carefully remove the Heater from the plastic bag and the carton.
2
Place the Heater on a stable flat surface.
3 Independent power supply socket will be inserted into the voltage according to
rating label. Rotate power knob, from OFF gear, the clockwise rotation, the LOW
dot for low power gear,fan and anion run automatically. MID dot for mid-range
power gear, fan and anion run automatically. HIGH dot for high-grade power
gear, fan and anion run automatically. When rotation to the power gears, the
indicator will light. OFF gear for power off, when Heater not in use, rotate the knob
to the OFF gear position, pull the plug out.
4
Thermostat control: The thermostat can control on and off of the Heater to keep the
room temperature at a desired level. Turn the TEMP knob to the maiximun position.
Once the desired room temperature has reached, turn the knob anti-clockwise
until the power indicator turn off (the Heater is temporary cut off). When the room
temperature has decreased, the Heater will turn on automatically, and will turn
off again when the desired temperature has reached. It is normal for the Heater to
cycle ON and OFF as it maintains the SET TEMP.
