18
EN
6. Ice making cycle begins,ice will be frozen onto the evaporator fingers.
Note
: Do not add water manually during the ice cube making cycle. The ice
making time depends on the ambient temperature
7. Once ice making cycle is finished,the water tray will tilt forward; the remaining
water flows back to the water reservoir and the ice cubes will drop from the fingers.
8. In about 15-35 seconds, the water tray will tilt backward,ice in produced in
previous cycle will be pushed to ice reservoir directly,unit back to work from step 4
to step 6 again
9. Push the ice cube dispenser puncher button(sketch 6) to get ice, the indicator
will be on.
Note
: Please put your cup below the ice cube dispenser shoot directly. If the ice is
stored in the unit for long time,the ice may freeze and stick together,then no ice will
be dispensed even the ice is full,if so,please kindly use scoop included in the unit to
break the ice first,then push the puncher button.
10. Press ON/OFF button to stop the unit.
11. When you push the WATER button, you can get water.
Note
: if you need to get cold water,at least the ice making function should be
turn on. Please make sure your cup is below the cold water outlet,or water will be
splashed everywhere.
12. If you need to take off the pipe,replace it or insert the anti drain plug,please do as
follows: Firstly take off the blue ring named as A,then press the white ring(lock) at
the outer side named as B. At last take out the pipe.
