23
EN
2.
Set the machine start time with the timer: Press the SET button 3 times, „88“ is
blinking in the hour display. Press the
button to set the hour. Press the SET button
once again, „88“ is blinking in the minutes display. Press the
button to set the
minutes.
3.
Set the machine power off time: Press the SET button 5 times, „88“ is blinking in the
hour display. Press the
button to set the hour. Press the SET button once again,
„88“ is blinking in the minutes display. Press the
button to set the minutes.
4. Timer setting: Press the
button to set the timer. You can choose between the
following function modes: Time to power on (ON)
Time to power off (OFF)
Timer off. Power on default time is 08:00 and power off default time is 12:00.
CLEANING AND CARE
1. Unplug the appliance from the wall outlet before cleaning it or if it will not be used
for an extended period of time.
2. Use a damp cloth to clean both the interior and exterior of the appliance.
3. Do not use organic solvents, boiling water, cleaning agents, strong acid, alkaline
solvents, etc. for cleaning.
4.
If the ice machine will be off use for a long time, you should unplug the appliance,
drain off the water and dry the appliance with a clean cloth. Store the ice cube
maker in a clean place.
Cleaning the water tank
First Phase:
• Add equal parts of water and vinegar (1:1) into water storage box.
•
In standby mode, keep pressing the On/Off button at least 5 seconds to activate
self-cleaning mode. Please note self-cleaning mode will automatically start after
beep sound.
• During the self-cleaning mode, pump will remain in continuous operation as it feeds
water to the bucket and evaporator coils. This cycle will continue for 5 times.
•
When self-cleaning is complete, the appliance automatically switches to standby
mode.
Second Phase:
• Remove the rear drain cap and drain plug, and then drain off the water and grip
the nut.
• Fill the water tank with fresh water up to the maximum permit water volume line.
•
In standby mode, keep pressing the On/Off button at least 5 seconds to activate
self-cleaning mode again which will now act as a rinse.
•
Upon completion of this final stage of the self-clean process, the unit automatically
changes to standby mode. Proceed draining the water from the internal reservoir by
removing the rear drain cap and plug. Leave the upper lid open to allow the water
tank to dry.
Summary of Contents for 10033774
