Klarstein VapoAir Onyx, Manual

16

EN

OPERATION AND MODES

Before first Use

•  For first Operation, put unit in the room temperature for half of an hour before 

running.

•  Use clear water not over 40 degree C

•  Check the water basin, make sure it is clear.

Getting Started

1.  Put the machine on a flat surface.

2.  When you take out of the water tank, you must be turn on the child safety lock
3.  Fill the water into the water tank, and then tighten the tank cover. 
4.  Put the water tank on the main base, and turn off the child safety lock.

5.  Plug into the socket. The display will be on and show current temperature. After 

30 seconds, it switches into current humidity. Temperature and humidity will switch 

every 30 seconds. If without any operation for 15 seconds, LED light will become 
dark. Press any button, LED be bright and enter related function.

AUTO Mode and Mist Speed

Touch the POWER button 

. 

•  If lack of water, display will show 

 and current temperature or humidity. 

• 

If there is enough water, display will show [AUTO]   and current temperature or 

humidity, and water tank light will be on.  

Device works in AUTO mode. (If it shows humidity before turn off, it will show humidity 
when turn on again. But it will switch into temperature after 5 seconds, and switch back 
to humidity after 30 seconds.) Touch POWER button again to turn off the device.

Touch the AUTO button

 to out of AUTO mode and the mist start from first speed until 

fourth speed for each touch. Touch the fifth times, it enters AUTO mode.