Instruction
manual
SDG
85
page
7
___________________________________________________________________________
5. Remarks in respect to the determined use
In combination with a 2 m high pressure hose it is not possible to work in a cable trench.
For this application you need at least a 3m pressure hose.
5.1. Operation of the unit
1.) Connect the cutting head (Pos.-No. 2) to the high pressure hose of the pump and roll
out the hose completely.
Attention
Use only hydraulic pump units with a high enough oil volume.
2.) Open the latch (Pos. # 4).
3.) Insert the cable into the open cutting head (Pos. # 2). Bring the cutting head into a 90°
cutting position towards the cable. The cutting head should not change its position
until the cut is completed.
4.) After actuating the pump the moveable cutting blade mounted on the piston
approaches the cable. The cutting cycles is terminated when the moveable and
stationary blade overlap.
5.2. Explanation of the application range
The hydraulic cutting tool type SDG 85 is able to cut copper as well as aluminium cables
and conductors even with a mild led fortification.
Attention
Do not cut cables or conductors with a steel enforcement.
Before starting to cut please make sure that all parts involved in the cutting process are not
connected to live circuits.
Attention
This tool is not insulated. Do not use on or near energised electrical
lines.
In order to take into account the various applications of the cutting head Klauke provides
hoses with the length of 3, 4, 5, 6, 8 and 10 m.
5.3. Service and maintenance instruction
The hydraulic tool must be cleaned and dried after each use. The unit is basically
maintenance free, only the guidances must be lubricated regularly and the tool has to be
inspected for possible damages and wear.
The hydraulic hose (Pos.-No. 5) and the armature must be checked for damage and
leakage.
