Instruction
Manual
page
10
______________________________________________________________________________________________________________________
5.4 Service and maintenance instruction
In case of broken moldings please return the tool to an authorised
service center.
Check the tool components regularly for damages and proper operation
and performance of their intended functions.
Have damaged cords and plugs repaired by a qualified serviceman.
For every day service the unit has to be cleaned and dried after each
use.
Within the determined use of the tool only the dies (Pos.-No. 10), the
adapters (Pos.-Nr. 4) are permitted to be changed by the customers.
Attention
Do not damage the seals of the tool.
If the seals are damaged the warranty is invalidated.
5.5 Storage and transport of the crimping tool
In order to protect the tool against damages it has to be cleaned
carefully after each use and be put into the transportation case which
has to be closed safely.
6. Troubleshooting
a.) The tool loses oil.
=>
Return the tool to the manufacturer. Do not open the tool and
damage the seals of the tool.
b.) The crimping tool does not reach the final operating pressure.
=>
Stop the crimping/cutting process. Press the retract button (Pos.-
No. 2) and the operating switch continuously and simultaneously for
about 10 sec. Is the malfunction not be eliminated by this attempt the
tool has to be returned to the manufacturer.
7. Putting out of operation/waste disposal
The disposal of the various components of the tool has to be treated
separately. First you have to dispose of the oil at special delivery
points.
Attention
Hydraulic oils represent a danger for the ground-water.
Uncontrolled draining of or improper disposal is under
penalty. (environmental liability law)
For the disposal of the remaining parts please reference the EC
environmental guideline.
Because of possible environmental damages we recommend to dispose
of the tool by professional companies. A return of the old tool free of
charge to the manufacturer cannot be granted.
8. Technical Data
Weight of the complete tool:
approx. 4,8 kg
Crimping force:
approx. 60 kN
Nennspannung:
110 V/50-60 Hz
Nennleistung: 200
W
Einschaltdauer: ED
5min/15min
Schutzklasse: II
Crimping time:
approx. 5 s to 8 s
(depending on the connector size)
Max. cutting diameter:
40 mm
∅
Cutting time:
8 s to 20 s
(depending on the cable size)
Punching time:
5 s with 22,5 mm
∅
, 3 mm St37
12 s with 60 mm
∅
, 3 mm St37
Hydraulic oil:
approx. 150 ml "Shell Tellus T 15"
Environmental temperature:
-20°C to +40°C
Sound level:
70 dB (A) in 1m distance
Vibrations:
< 2,5 m/s²
Dimensions:
See Picture 7
Note
Additional instruction manuals are available free of charge. The part # is
HE.12532.
