KLAXON Mobility Gmbh – ENG
KLICK Electric User's Manual (ENG) - rev.6.1 of 15.06.2018
21
•
Push the handlebar forward with one hand grasping it in the middle and simultaneously press the release button on the
CONNECTOR with the other hand. This frees the lower pin of the KLICK coupling (Figure 34).
•
Reduce forward pressure on the handlebar while holding the release button on the CONNECTOR, thus lowering the
wheelchair so that its front wheels make contact with the pavement (Figure 35).
At this point the upper pin will already be pulled out the front hook of the CONNECTOR; release the wheelchair
’
s brakes and push
yourself back to move away from the KLICK device (which in the meantime will remain upright thanks to its KICKSTAND - Figure
36).
Remove the CONNECTOR, pulling the lever located on its bottom (Figure 20).
DANGER
During the KLICK release operation, pay attention to not endanger the top parts of your body
(fingers, hands, arms) as they could be affected by the sudden movement of the handlebar (or other
parts of the device) if it is released too quickly. To avoid this danger, after pressing the release
button, gently release the handlebar by lowering the wheelchair gradually.
16.5 CLOSING / OPENING FOR TRANSPORTATION
To perform the operation properly, carefully follow the following instructions.
•
Make sure that the device is off and the safety button on the battery disabled (Figure 46).
•
Loosen the safety rings on the handlebar, turning them counter-clockwise with respect to the “ON” arrow (Figure 64).
•
Move the safety rings outwards, unlocking the handlebar and making it collapse downward (Figures 65 and 66).
•
Push up the safety button on the release lever and pull the latter outwards until it is completely disengaged (Figures 67 and
68).
•
Fold the upper part of the handlebar to the side, rotating it 180 degrees; in closed position, it shall lie alongside the lower
part of the steering tube, beside the battery holder (Figure 69).
•
To open the Klick device, perform the above operations in reverse order.
CAUTION
During the closing phase of Klick Electric Mini, pay the utmost attention not to damage the (electric
and mechanic) wires that run inside the frame of the device. Perform the opening and closing
operations slowly, making sure that the wires do not interfere with moving parts, as these could
pinch or break.
DANGER
If some elements of the electric or mechanic system get damaged during the opening and closing
of the Klick Electric Mini device, do NOT absolutely use the device and take it immediately to an
authorized KLAXON service centre.
DANGER
Once the Klick Electric Mini has been opened, before using it check that all joints are properly closed
and that safety buttons (side lever and handlebar rings) are fully fastened. Only use the device
when it is completely open (Figure 70).
17. CLEANING
Regularly cleaning the entire device makes it last longer and work better.
We recommend to:
•
Before cleaning, switch the device off and disconnect the battery charger.
•
Do not use abrasive cleaning agents, detergents and high pressure cleaners.
•
Clean the device with a soft, damp cloth.
•
Thoroughly dry the device after use in the rain.
•
If the device is soiled, soften the dirt and remove it as soon as possible; then dry the device carefully.
•
Clean all the outside of the device at least once a month and after each ride on muddy terrain.
•
Be careful not to wet the electrical parts (battery, display, motor).
•
Do not wash the parts under running water
•
Dry the parts immediately after washing, using a soft cloth.
•
If the electrical parts get wet, let them dry and do not use the device until they are completely dry.
18. SERVICING
KLICK devices must be serviced regularly, to ensure safe, reliable and efficient operation.
KLAXON is not responsible for any damage caused by non-maintenance or by insufficient maintenance, and in said cases the
warranty may lapse.
Unscheduled maintenance can be carried out only by technicians authorised by KLAXON's Technical Support Service.
18.1 PERIODICAL MAINTENANCE
We recommend the following regular maintenance:
•
At least once a month, check the tyre inflation pressure; a flat tyre affects the vehicle's smooth ride, its safety and its power
consumption.
