KLAXON Mobility Gmbh – ENG
KLICK Electric User's Manual (ENG) - rev.6.1 of 15.06.2018
22
•
At least once a month, check wear of the tyres. To replace an inner tube or a tyre, contact an authorised KLAXON technician.
•
At least once every two months, check the tightness of all screws and fasteners.
•
At least once a month, check the tightness of the fixing nuts of the wheels’ pins with a torque wrench calibration at 30Nm
(Electric, Electric Tetra, Mini versions).
•
At least once a month, check the tightness of the fixing nuts of the wheels’ pins with a torque wrench calibration at 50Nm
(Race, Monster versions).
•
Before each use, check proper operation of the accelerator and brakes: any replacement of parts subject to wear (brake pads,
discs, brake system in general) should be carried out only by authorised KLAXON technicians. The vehicle should also be
checked whenever you feel the braking power has decreased.
•
Check the condition of the battery, before each use. To replace the battery, and any other electrical component, contact only
authorised KLAXON technicians.
Have a KLAXON qualified technician overhaul the entire device at least once a year, and/or whenever a
malfunction occurs.
18.2 MALFUNCTIONS
If you encounter a malfunction during use of the KLICK device, contact KLAXON or of its authorised resellers.
Malfunction found
Possible cause
Corrective action
The device does not turn on (Electric
version)
The battery is empty
Recharge the battery
The battery is positioned
improperly
Check the position of the battery by removing it
and inserting it again, making sure that the
electrodes are inserted in the appropriate
spaces.
General problems
Contact an authorised KLAXON service centre
It vibrates excessively during use
Loose screws
Contact an authorised KLAXON service centre
The display lights up but the device does
not move
Disconnected plug
Contact an authorised KLAXON service centre
You have problems coupling the traction
unit to the connector
The connector is not adjusted
properly
Contact an authorised KLAXON service centre
You have problems attaching the
connector
There is dirt inside the coupling
seat in the crossbeam
Clean the surfaces of the seat in the crossbeam
and of the mounting system in the connector
You have problems attaching the
connector
The interlocking balls do not
retract when pulling the lever
Contact an authorised KLAXON service centre
Wheelchair front wheels touch the
ground
The Klick coupling is mounted too
low
Contact an authorised KLAXON service centre
KLICK is noisy when in use
The fender touches the wheel
while moving
Make sure your feet are in a position that does
not interfere with the fender of the device
Reposition the fender, putting it back into place.
The brake pads touch the disc
when reversing
Contact an authorised KLAXON service centre
18.3 FLY SLIM Battery (2.5 Ah)
The FLY SLIM battery (36 V and 2.5 Ah) is cylindrical and secured to the connection with an elastic rubber strap (Figure 44).
On the top of the battery, there are markings along which some LEDs show the current charge level: pressing the button, the LEDs
will show the approximate charge level, in four levels (20%-50%-80%-100% - Figure 45).
Another button (red) turns the battery on/off, pressing this button will power the motor and the display (Figure 46).
The rubber strap, on the side of the battery, holds the battery on the device. Remove the strap to release the battery, pulling it
forward and upward (Figures 47 and 48).
To charge the battery:
•
Turn the device off (by pressing and holding the “
M
” button);
•
Remove the battery by pulling out the rubber strap on the side (Figures 47 and 48).
