G
as
A
djustment
1
2
Injector
Control handle
Tap
Sealing ring
Remove the pan support,
burner cap
and
burner head.
Unscrew the injector using a 7mm box spanner and
replace it with the stipulated injector for new gas supply.
Carefully reassemble all components.
After
the
injectors are replaced, it is advisable to tighten
them firmly in place
.
Adjustment of minimum level of the flame.
Turn the taps down to minimum
.
Remove the knob from the tap and place a small
bladed screwdriver in the centre of the tap shaft.
The correct adjustment is obtained when the flame
has a length of about 3 - 4 mm.
- For butane / propane
/ULPG
gas, the adjusting screw
Repeat this process for each one of the gas taps.
must
be tightly screwed in.
Refit the control knob.
Make
sure that the flame does not go out by
quickly
turning
from maximum flow to minimum
flow. If it does then remove the control knob and
make further adjustments to the gas flow, testing it
again once the
adjustment has been made.
Ŷ7DNHSUHFDXWLRQVRQWKHRSHUDWLRQVDQGDGMXVWPHQWVWREHFDUULHGRXWZKHQ
FRQYHUWLQJIURPRQHJDVWRDQRWKHU
Ŷ$OOZRUNPXVWEHFDUULHGRXWE\DTXDOL¿HGWHFKQLFLDQ
Ŷ%HIRUH\RXEHJLQWXUQRIIWKHJDVDQGHOHFWULFLW\VXSSO\WRWKHDSSOLDQFH
-
Ŷ%HIRUHSODFLQJWKHEXUQHUV
EDFNRQWKHWRSSOD
t
HPDNHVXUH
WKDWWKHLQMHFWRULV QRWEORFNHG
FDUULHGRXWDIWHUJDVFRQYHUVLRQ
VXFKDVVRDSZDWHURUJDV
DTXDOL¿HGWHFKQLFLDQRULQVWDOOHU
must
PDUN³9´RQWKHULJKWJDV
FDWHJRU\
WRPDWFKWKH
VHWWLQJLQUDWLQJSODWH
5HPRYHWKH³9´PDUN
from the
previous setting
LQWKHHYHQWRIDPDOIXQFWLRQ
FKDQJHWKHZKROHWDS
Ŷ$IXOORSHUDWLRQDOWHVWDQGDWHVW
IRUSRVVLEOHOHDNDJHVPXVWEH
Ŷ$IWHUFRPSOHWLQJFRQYHUVLRQ
GHWHFWRU
Change the injector of the burners.
Ŷ
Do not dismantle the tap shaf
t
:
Attach the ULPG sticker to the cooker, near the gas
supply inlet. Cover the Natural label that is factory
fitted.
5
24