15
The installation and technical assistance must only
be performed by qualified staff. Carefully read the
safety instructions in this manual before using the
oven. Incorrect installation, maintenance, assistance
and use can cause serious damage/injury to persons
or objects
This product must be installed as instructed in this
manual and in compliance with National Standards
and local regulations in force.
Do not lift or pull the oven from the door handle and
do not force or load weights when this is open.
The purchaser is responsible for installation.
Assistance provided by the manufacturer due to
incorrect installation is excluded from the warranty.
Features of the cabinet
The technical requisites of the cabinet are the following;
– The cabinet and its components must be able
to withstand temperatures of up to 90°C without
presenting deformities and/or surface defects.
– The cabinet must enable the free passage of the oven
connections.
– All household kitchen units must be protected with fire-
resistant material in accordance with the standards in
force.
Inserting the oven in the cabinet
It is important that all operations relating to installation of
the device are carried out by qualified staff. The oven can
be installed in a column or below the worktop of a kitchen
cabinet.
Built-in measurements
The dimensions of the opening to be made in the cabinet
for fitting the oven are indicated in figures. Ensure that the
cabinet where the oven is to be installed, is able to support
the weight of 30 kg. For the opening in the cabinet follow
the dimensions in the respective figure.
It is necessary to create an opening in the rear part of the
bottom of the cabinet or in the oven support shelf, to allow
sufficient air to circulate for the cooling of the oven during
functioning.
Ensure the oven is safely installed inside the cabinet. Use
screws to fix the oven to the front face of the cabinet.
Electric connection of the oven
FIXED WIRING:
Ensure the electric current has been disconnected
before connecting the oven to the electric mains.
The oven requires single-phase alternate current 220-
230-240 V~ 50-60 Hz, using flexible cable. Ensure the
household power supply can support the electric load
of the device. (see serial plate). The electric safety of
this appliance is only assured if the same is correctly
connected to a system having efficient earth connection,
according to the legal Standards in force.
In case of permanent connection to the electric mains,
apply a bipolar switch dimensioned to the corresponding
load, with opening for each contact of at least 3 mm in
accordance with the current local regulations.
The installer must ensure that the switch is suitable for the
power absorbed by the oven as indicated on the serial
plate.
The switch must be easily accessible. Disconnection of
the appliance from the electrical supply by the user must
be allowed for.
Installation instructions
