TJXTREME
Installation and Operation Manual
PG 21/36
REV: A (5/8/2020)
8.3.
Disassemble Trumpets from Air Horn Drivers
8.3.1.
Remove Air Horns and included Air T-Fitting from packaging; Air Tubing and Hardware are not used.
8.3.2.
Disassemble Trumpets from Air Horn Drivers by firmly grasping Trumpet around Metal/Chrome Collar and
twisting counter-clockwise, as shown below. If necessary, use pliers with rag or soft material over jaw.
Figure 7
–
Removing Trumpets from Air Horn Drivers, Exploded View
8.4.
Assemble Air Horn Drivers to Bracket (TJ-101)
8.4.1.
Hardware #H9, H10, H11, H12, & H13
, install Air Horn Drivers, as shown below. Snug-tighten
fasteners only, as Drivers may need to be repositioned to install Bracket on vehicle for bolt access.
NOTE A:
when installing Air Horn Drivers, they are identical, but critical they are positioned such that
attached Air Fittings face outward, as shown in illustration (i.e., fittings oppose each other)
NOTE B:
discard included white plastic protector, attached to bottom of each Driver before attaching
Figure 8
–
Air Horn Drivers Installation to Bracket, Exploded View (Showing Air Compressor)
GRASP HERE
K3
–
DRIVERS
GRASP HERE
H11
H12
H10
K3
H9
NOTE A
NOTE B
