TJXTREME
Installation and Operation Manual
PG 33/36
REV: A (5/8/2020)
If your vehicle is equipped with factory upfitter (i.e., auxiliary) switches, you may elect to use them for
your Kleinn Air Horn kit; consult Owner
’
s Manual, or dealership for further instructions on what wire
terminals/fuse block location to use and programming required.
10.5.2.
Drill a 3/4” hole at location. Route horn button wires to hole then slide push
-button retaining nut over
wires and connect wiring. Install push-button into hole and tighten retaining nut from backside.
10.6.
Connect Pressure Switch
10.6.1.
Route wiring, as desired back to Air Tank and connect to Pressure Switch, per wiring diagram.
10.7.
Connect Air Compressor
10.7.1.
Route wiring, as desired back to Air Compressor and connect, per wiring diagram.
10.8.
Connect Air Horn Solenoid(s)
10.8.1.
Route wiring, as desired up to Air Horn and connect to Solenoid(s), per wiring diagram.
10.9.
Secure Wiring to Vehicle
10.9.1.
Insert all wiring into included wire loom and ensure loom is away from all sharp edges, hot vehicle parts
(i.e., exhaust, engine, radiator), and fasten securely to vehicle using supplied zip ties, or equivalent.
End of Section
