RAMHD-734KIT6450
Installation and Operation Manual
PG 3/32
REV: A (08/05/2022)
1.
Safety First
Read manual thoroughly before starting installation of this kit. Verify you have all parts listed and that you
clearly understand this installation procedure. Contact Kleinn technical support for any questions.
Installation of this kit requires
moderate mechanical aptitude
; seek professional help if you’re not competent
using hand tools in tight uncomfortable spaces, and around possibly rusted and sharp vehicle parts.
Before starting, obtain proper tools required to perform installation correctly, adequate lighting, eye protection,
hearing protection for operating train horns, and hand protection to guard against sharp edges and metal burrs,
which may be present on kit and vehicle parts.
2.
Application Chart
RAMHDOBA-6450 is a bolt-on aftermarket product for all DODGE vehicles listed in below chart.
All vehicles listed may require drilling holes for ground wires and installing switches, based on preference of
switch locations and wire grounding points.
MODEL YR
MODEL
DRIVE
ENGINE
BODY
TRIM
2014-2021
RAM 2500
2WD, 4WD
ALL
Crew Cab (
short
bed**),
Mega Cab
ALL
2014-2021
RAM 3500
2WD, 4WD,
DUALIE
ALL
Crew Cab (
short
bed**),
Mega Cab
ALL
**Exclusions:
Crew Cab Long Bed, or Regular/Standard Cab frames; these frames will require drilling holes to attach the
following brackets. Contact Kleinn sales for more information.
Compressor Bracket – drill mounting holes for hardware in approximate location shown in instructions
Product Compatibility:
This kit has been designed and tested to be compatible with leading manufacturers of aftermarket truck steps,
such as Amp Research Power Steps ® and all OEM standard and optional steps.
