GMTRK4
Installation and Operation Manual
PG 31/42
REV: BETA (4/4/2020)
9.5.
Connect Air Compressor Leader Hose to Air Tank
9.5.1.
Route Air Compressor Leader Hose to proper Air Tank port, as shown below.
9.5.2.
Apply two small drops of Kleinn Air Horn Juice to male pipe thread on end of Leader Hose and hand
tighten; use wrench to further tighten 1/4-1/2 Turn.
CAUTION:
do NOT over tighten
“
Leader End
”
of Leader Hose onto Fitting; over tightening may
damage one-way ball valve.
Read all instructions accompanying Air Compressor thoroughly.
9.5.3.
Secure Leader Hose to Bracket using supplied zip ties.
Figure 22
–
Air Compressor Leader Hose Route & Zip Ties (Shown as if installed in vehicle)
FITTING
Zip Ties (3)
LEADER
END
LEADER
HOSE
