GMTRK4
Installation and Operation Manual
PG 8/42
REV: BETA (4/4/2020)
4.
Application Chart
4.1.
Bolt-On Vehicle List
GMTRK4 is a direct bolt-on aftermarket product for GM vehicles listed in below chart; every effort has been
made to verify correct fitment on these vehicles in their factory, non-modified conditions.
MODEL YR
MODEL
DRIVE
ENGINE
BODY
TRIM
2019-2020
SILVERADO 1500
ALL
ALL
ALL
ALL**
2019-2020
SIERRA 1500
ALL
ALL
ALL
ALL**
NOTE: All vehicles listed may require drilling holes for ground wires and installing switches, based on
preference of installed switch locations and wire grounding points.
It is also recommended to shorten one OE Bolt by cutting/grinding its non threaded end to provide Air Tank
clearance
–
see Mechanical Assembly section.
4.2.
**Excluded Vehicles
4.2.1.
N/A
4.3.
Aftermarket Product Compatibility
4.3.1.
This kit has been designed to be compatible with following products from leading manufacturers:
•
Most aftermarket suspension systems that directly-bolt on (i.e., utilize OE mounting points)
•
Aftermarket power steps and rocker steps/running boards
•
Aftermarket exhaust systems
4.3.2.
This kit has NOT been designed
to be compatible with any of the following products:
•
Aftermarket front bumpers that do not have same empty space behind Driver’s side of OE
bumper
•
Aftermarket fender flares that require cutting rear bed sides and OE rock guarding
NOTE: Review this manual in full before unpacking items and verify correct space and mounting locations
exist with your aftermarket product(s).
To install this kit alongside your other aftermarket product(s),
modification to included parts, your vehicle, or aftermarket product(s) may be required.
End of Section
