GMTRK4
Installation and Operation Manual
PG 24/42
REV: BETA (4/4/2020)
8.5.
Insert Square Neck Bolts onto Brackets (GMTRK-4-102, 201)
8.5.1.
press each Carriage/Square Neck Bolt into corresponding square holes in GMTRK-
4-102 Plate, as shown below. It may be necessary to use a deep socket and rubber mallet to set each
Bolt flush. This step is required to facilitate installation in Vehicle.
NOTE:
if any Bolts fit loosely, secure them to back side of Bracket using electrical tape or similar.
Figure 11
–
GMTRK-4-102 Plate with Bolts pressed in place (Exploded View)
8.5.2.
Hardware #H1 & H5
with GMTRK-4-201, as shown below.
Figure 12
–
GMTRK-4-201 Tank Bracket with Bolts pressed in place (Exploded View)
End of Section
M2
SOCKET
H5 (2)
M5
H1 (4)
SOCKET
H5 (2)
