JL-JK-OBA
Installation and Operation Manual
PG 21/35
REV: A (1/21/2019)
9.
Bench Assembly Steps
Complete following steps off vehicle to facilitate final installation.
NOTE:
ALL HARDWARE WILL BE SPECIFIED IN INSTRUCTIONS USING ITEM NO.’S FOUND IN PARTS LIST.
Assemble ALL fasteners clean and dry using proper socket and box-end wrench. (Not including Air fittings)
9.1.
Air Tank Fittings
9.1.1.
Apply two small drops of
9.1.2.
Attach air fittings to tank, per below illustration,
Click Here to View Fittings List
9.1.3.
Hand-tighten each fitting, then further tighten each 1/4-1/2 turn using proper sized box-end wrench;
adjust as necessary to match fitting orientation shown in above figure.
5/7*
3
4
8
5
6
To Air Coupler
5
5
7
Compressor In
