RAMHD-230/734KIT
Installation and Operation Manual
Go to Table of Contents
PG 6/41
REV: BETA (2/19/2018)
3.
Application Chart
3.1.
100% Direct Bolt-On Vehicle List
RAMHD-230/734KIT is a 100% direct bolt-on aftermarket product for DODGE vehicles listed in below chart;
every effort has been made to verify correct fitment on these vehicles in their factory, non-modified conditions.
MODEL YR
MODEL
DRIVE
ENGINE
BODY
TRIM
2014-2018
RAM 2500
2WD, 4WD
ALL
Crew Cab (
short
bed**),
Mega Cab
ALL
2014-2018
RAM 3500
2WD, 4WD,
DUALIE
ALL
Crew Cab (
short
bed**),
Mega Cab
ALL
NOTE: All vehicles listed may require drilling holes for ground wires and installing switches, based on
preference of installed switch locations and wire grounding points.
3.2.
**Excluded Vehicles
RAMHD-230/734KIT may not be compatible with following DODGE vehicles:
1.
All Crew Cab Long Bed model years listed
2.
All Regular/Standard Cabs model years listed
Kit may be adapted to these vehicles, with vehicle modification:
1.
Small Horn Bracket
Drill mounting holes in vehicle chassis at approximate location shown in instructions
2.
Compressor Bracket
Drill mounting holes in vehicle chassis at approximate location shown in instructions
CAUTION:
All vehicle modifications are at discretion of end-user/installer; this manual does NOT
provide instruction, or encourage such modification. Contact Kleinn sales for more information.
3.3.
Aftermarket Product Compatibility
This kit has been designed and tested to be compatible with leading manufacturers of aftermarket truck steps,
such as Amp Research Power Steps ® and all OEM standard and optional steps.
