Make sure that handle pin is
completely through the handle
and resting on the other side.
Drive in the spring pin using a
hammer.
Pull down on the handle to
release the tension on the safety
pin. CAREFULLY remove the
safety pin.
Feed the chain and nut first back
inside the handle THROUGH the
handle pin’s center hole.
***IMPORTANT - TIP ***
Release the up/down lever to
its lowest position to make the
process easier.
Once the chain is in the proper
position, check to see that it
moves freely and that it is not
obstructed.
Feed the end of
the chain into the
cam.
Pump the lever a few times to
raise the forks. Put the up/down
lever to its nEUTRAL position.
Using a 14mm wrench and a
flat screwdriver, adjust the valve
cam so that the forks don’t lower
or rise (if handle is pumped) at
this position.
*** IMPORTANT - FINAL CHECK ***
The handle should be pumped with full strokes to
prime and eliminate air in the system. The up/down
lever should be checked at the handle’s lowest
position as this puts the most tension on the chain.
5.
6.
7.
8.
9.
10.
11.
12.
