103 rue Louvain Ouest, H2N 1A3, Montreal
8
USER GUIDE HUB2
| VERSION 1.3
6.
Installation
6.1 Installation
The HUB2 might be install near a wall or an AC outlet for big event. The battery can run less than a day
without charging (depending on the usage of these). The HUB2 also need to be out of sight of people and
not in a restricted place to be sure that the data is correctly send to the server. The HUB2 can always be
plug.
6.2 Orientation
The HUB2 orientation depends on the Antennas orientation. The HUB2 can be placed on the floor, on the
wall or under object, but the Antenna must always be placed in vertical position for a maximum coverage.
To have a good coverage, the HUB2 must be place in the center of a pieces, unfortunately in realistic
event, it may not be possible due to the AC outlet and the need to be out of sight of people. So it is
recommended to place it in a hidden place near a wall. A place than will have the maximum coverage with
or without thick wall. See image below for an exemple.
6.3 Connections
The user only need to be sure the phone is correctly plug on the HUB2, the antenna is there and the
battery is charged.
