Multiplexer
4 Multiplexer Hardware Options (available on request)
A8
KLIPPEL Analyzer System
Page 6 of 16
Multiplexer Hardware Options (available on request)
BYPASS
BUS B
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
BUS A
IN 1
IN 2
IN 3
IN 4
OUT 1
OUT 2
OUT 3
OUT 4
•
Signal from channel 1 is bypassed to channel 5 if channel 1 is not selected
(channel 2 to channel 6, 3 to 7, 4 to 8)
•
Allows to switch one measurement device into the signal path of up to 4
channels while the other channels are still connected
•
Must only be used in
Dual Parallel 1 out of 4
routing mode
BYPASS SWITCHABLE
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
BUS A
BUS B
IN 1
IN 2
IN 3
IN 4
OUT 1
OUT 2
OUT 3
OUT 4
•
Same functionality as option “Bypass”
•
Each of the 4 signals can be controlled in the following modes:
•
Signal switched of
•
Signal bypassed (direct connection from input to output)
•
Signal is routed thru the measurement device
•
(BUS A = Send to meas. device, BUS B = Return from m. d.)
•
Multiplexer can be used in all routing modes. (Bypass switched off)
SHORTCUT
•
Deselected channel is shorted permanently.
SHORTCUT SWITCHABLE
•
Deselected channel 1 to 4 can be shorted. The shortcut is controlled in
the same way as the Bypass Switchable relays.
•
Deselected channel 5 to 8 can be permanently shorted or permanently
open.
PERMANENT GND
•
Permanent connected GND from all channels is available as option for
the Line versions