Klippel R&D System
KCS-ID Manual
9
1.
Open the KCS-ID operation which lead to an insufficient
X
max
and copy the operation.
2.
In the KCS-ID
Properties
(category
Stimulus)
, change the
Level
from
Automatic
to
Manual
3.
Increase the level depending on how much you want to increase the
X
max
compared to the
previous measurement.
4.
Repeat the measurement and create initial data with higher
X
max
using the KCS Server again.
1.7
Transducers with multiple voice coils
Initial KCS data can also be created for transducers with multiple voice coils, each driven by a
separate amplifier channel.
Note:
KCS only supports multi coil configurations if all coils show identical small and large signal
properties. Please contact Klippel if you are unsure if your transducer is suited.
Dual Coil Speaker
KA3
Amplifier
Input
Output
Laser
Microphone
1
2
Hardware connection for double voice coil speakers
To create the data, you need to run the KCS-ID operation with the voice coils connected in series as
shown above for a dual voice coil speaker.
Note:
Due to the series connection, the peak voltage demands of KCS-ID for the amplifier will rise
according to the number of voice coils. Make sure that your amplifier can deliver the required peak
voltage.
