EN - 20
are opened more frequently, especially if
the humidity of the room is high.
The door does not open or close
properly
Check if:
•
There is food or packaging preventing the
door from closing
•
The door joints are broken or torn
•
Your
appliance
is on a level surface.
•
The compressor can run loudly or the
noise of the compressor/refrigerator
may increase in some models during
operating in some conditions such that
the product is plugged in for the first time,
depending on change in the ambient
temperature or change of usage. That
is normal; when the refrigerator reaches
the required temperature, the noise
decreases automatically.
8
TIPS FOR SAVING ENERGY
1.
Install the appliance in a cool, well-
ventilated room, but not in direct sunlight
and not near a heat source (such as a
radiator or oven) otherwise an insulating
plate should be used.
2.
Allow warm food and drinks to cool
before placing them inside the appliance.
3.
Place thawing food in the refrigerator
compartment if available. The low
temperature of the frozen food will help
cool the refrigerator compartment while
the food is thawing. This will save energy.
Frozen food left to thaw outside of the
appliance will result in a waste of energy.
4. Drinks or other liquids should be
covered when inside the appliance. If
left uncovered, the humidity inside the
appliance will increase, therefore the
appliance uses more energy. Keeping
drinks and other liquids covered helps
preserve their smell and taste.
5. Avoid keeping the doors open for long
periods and opening the doors too
frequently as warm air will enter the
appliance and cause the compressor to
switch on unnecessarily often.
6.
Keep the covers of the different
temperature compartments (such as the
crisper and chiller if available) closed.
7. The door gasket must be clean and
pliable. In case of wear, replace the
gasket.
9
TECHNICAL DATA
The technical information is situated in
the rating plate on the internal side of the
appliance and on the energy label.
The QR code on the energy label supplied
with the appliance provides a web link to
the information related to the performance
of the appliance in the EU EPREL
database.
Keep the energy label for reference
together with the user manual and all other
documents provided with this appliance.
It is also possible to find the same
information in EPREL using the link https://
eprel.ec.europa.eu and the model name
and product number that you find on the
rating plate , the appliance.
See the link www.theenergylabel.eu for
detailed information about the energy label.
10
INFORMATION FOR TEST
INSTITUTES
Appliance for any EcoDesign verification
shall be compliant with EN 62552.
Ventilation requirements, recess
dimensions and minimum rear clearances
shall be as stated in this User Manual at
Chapter 2. Please contact the manufacturer
for any other further information, including
loading plans.
