4
Gas Connetion
Before montage , make sure the system of local gas supply compatible with applience. In order to do this,
you can profit from the label of applience and board on the operating manual.Bearing in mind asset norms ,
gas connection must be made by specialized clerk. If ıt is used metal pipe for connetion , make sure it
doesn't get in touch with active pieses or will not come under impackts. Connection procedure ….
Gas connection's cock is G ½ sprocket .
After making connection , in order to check lible gas leakage you must wash with saponated water .
Instruction For Use
Security gas burner
Some models of these devices automatically shuts off the gas supply in the event one of the burners goes out
accidentally as a result of a sudden draught, a pot spilling over, or an interruption in the gas delivery.
Usage of gas burner:
For better use of the burners and more efficient gas consumption, use pans whose diameter is proportional
in size to that of burners. Ensure that flames do not extend beyond the edge of pans.
Choosing right burner:
WARNING:
Do not use the system of ignition more than 15 seconds. If the burner doesn't blaze, wait a minute for this
period.
Take the ignition knob to “maximum gas delivery” position. Keep the knob pressed down for 4 or 5 seconds
in order to allow the sparks to ignite the gas as it exits through the flame-spreader crown and release the knob
and turn it anti-clockwise to adjust the flame to the desired setting.
Usage of grid;
Make sure that the grid position right. Check the rubber protection under the grid.
