6
MOD-KOZE-50 - mounting instructions
c) Preparation of the OMODO-50 lighting fixture
www.KlusDesign.eu
7.
8.
a.
holes for locking bolts ø 2,5 mm / 0.1”
item
(1.2)
b.
hole for a gland ø 6,5 mm / 0.26”
a.
Drill holes for locking bolts in the
profiled orientation line in the profile
(2.1)
.
The number of holes must be equal
to the number of bolts used. Each
hole should be in the middle of the
corresponding item
(1.2)
. There must
be a minimum of two bolts per 1
meter of a profile.
b.
Drill a hole in the profile
(2.1)
for the cable gland.
Adhere the LED tapes
(4)
, mount
the gland
(5)
and route the power
cable through it.
Attach end caps to the item 2.1
(7)
with the bolts
(8)
.
Locking bolts
(2.2)
can be
tightened preliminarily in the
pre-drilled holes before mounting
the profile at its destination
(after mounting the LED tapes).
Mount the power supply
(6)
on
the back of the profile in such
a position that it fits into the
opening of the RAM-KOZE-50
profile.
Run the power cable to the
power supply through one of the
channels in the profile
(2.1)
,
so that it does not protrude
above the surface.
bottom view
IIc
IIIc
6.
4.
7.
8.
7.
8.
5.
2.1
Ic
1.2
2.1
1.2
1.2
1.2
6.
2.1
1.2
top view
2.2.
