Page 6 of 11
Specific Operation Warnings
⚠
WARNING
•
Read and understand owner's manual before use.
•
Do not exceed the tire's rated pressure.
•
Always wear gloves. Some exposed parts may become hot during use.
•
Use extreme caution when connecting the unit to a power source, as batteries can vent explosive
gasses.
•
Do not use the unit for pumping, compressing, or transferring any gas or liquid other than air. The
unit is not designed for the sourcing of breathable air.
•
Compressed air and particulate matter can cause eye and soft tissue damage. Keep air stream
away from skin and eyes.
•
Clean with a damp cloth only. Do not use chemicals or soap.
•
Do not modify or attempt to repair the product. There are no serviceable parts inside the unit; do
not disassemble.
•
The compressor was permanently lubricated during assembly. Do not add oil or any other
lubricant.
•
Burn hazard. The unit will become hot during use. Use caution when touching the unit.
•
Do not operate continuously for more than 15 minutes. If the unit gets hot, switch it off and allow it
to cool before continuing operation.
•
Use a second tire pressure gauge to verify the tires are inflated to the proper pressure.
Before Each Use
⚠
WARNING
If using your car battery to power the unit, Start and run engine in a well-ventilated area.
Operating Instructions
⚠
WARNING
•
Place the product on a dry, level surface.
•
It will become hot during operation. Be careful when removing the metal quick connect host fitting.
•
After 15 minutes of continuous operation, allow the unit to cool before restarting. Damage can
occur from continued over-use.
•
Pay close attention to the pressure gauge. Be prepared to stop the inflator quickly when the
recommended inflation pressure is reached.
•
Burn hazard. The unit will become hot during use. Use caution when touching the unit.
Connection
1. Use the quick connects fitting to connect the air supply hose to the product.
2. Slide the retaining snap ring back.
