Fig.1
Fig.2
Fig.4
Fig.3
ASSEMBLY INSTRUCTIONS
THIS TREE IS FOR INDOOR USE ONLY!
Retain carton and instruction sheet for storage and further purposes.
Each carton contains three tree sections
ABC
and one metal stand
D
.
1. Choose a location where the tree is to be displayed.It should be on a level surface.
Make sure final assembly stable enough to hold the tree upright.
2. Take out the metal stand and assemble as below figures shown.
1) Tree stand consists of a metal stand and a single eye bolt as Fig.1.
2) Open the stand to a 90 degree angle until the hole lines up with the hole on the tube as Fig.2.
3) Insert the tree bottom
C
into the hole as Fig.3.
4) Screw the eye bolt to tighten the tree bottom.
3. After tighten the tree bottom
C
into metal stand
D
,insert the middle section
B
into tree bottom
C
,
then insert tree top
A
into middle section
B
as Fig.5.
When assemble, you should insert the pole as Figure direction.
4. Open all hinged branches easily, allow the branches to fall into place or gently pull branches
up and out,then shape the branches. Starting with tips closest to the pole,shape one tip to the
right,one to the left and one at the center of the main steam. Repeat pattern for each
branch as Fig.6.
5. You can add holiday decorations to beautify this tree.
6. The tree is pre-strung and has powered tree pole,you can connect the plug to the wall outlet
directly without extra light connection. All lights should illuminate completing the assembly of
your tree! Enjoy your holiday!
Please note this tree is LYTE SYSTEM
TM
("Light Your Tree Easy" System)
STORAGE
First unplug the power cord from the wall outlet.
Remove all holiday decorations,disassemble the three tree sections and secure them in place.
All tree parts can be replaced in its original carton and should be stored in a cool and dry place.
WARNING FOR SAFETY USE
1. Never allow any part of the tree to contact a source of heat or flames.
2.
Caution:
Artificial trees have small parts which may pose a choking hazard if detached
TROUBLE SHOOTING TIPS
For pre-lit trees, if the tree does not illuminate:
1. Please check to make sure that the power cord is plugged into the wall outlet.
2. Please check for loose,broken or missing light bulbs and replace as needed.
3. Please check the plug fuse and replace as needed.
4. This tree is powered pole, if the powered pole connection is loose,
please email us for solution.We can replace one extention cord.
SPARE PARTS
For pre-lit tree, plug fuses and bulbs are included.
Please check attached manual for replacement guide.
If extra parts are needed, please contact our customer service center.
Email: customerservice@winnersarts.com or Call toll-free: 1-844 946 8733
Fig.6
4. Always fully insert electrical plugs into a receptacle.
from the branches.
3. Always position your tree light string cord or any extension cord so that they will not be a
hazard to the elderly,children and pets.
Powered Pole Assembly Direction
Fig.5
