KMC Controls BAC-9300 Series, Installation Manual

BAC-9300 Series Controller Installation Guide 

6 925-019-02G

CONFIGURE/PROGRAM THE CONTROLLER

See the table for the most relevant KMC Controls 

tool for configuring, programming, and/or creating 

graphics for the controller. See the documents or 

Help systems for the respective KMC tool for more 

information.
See the table (on the next page) for the most 

relevant KMC Controls tools for configuring, 

programming, and/or creating graphics for the 

controller. See the tools’ documents or Help 

systems for more information.

NOTE: 

After the controller has been 

configured, an STE-6010/6014/6017 

series analog sensor can be connected 

to the controller in place of an STE-

9000 series digital NetSensor.

NOTE: 

A BAC-9301C

E

 can be configured by 

connecting an HTML5-compatible 

web browser to the controller’s default 

IP address (192.168.1.251). See 

the 

Conquest Ethernet Controller 

Configuration 

Web Pages Application 

Guide

 for more information about the 

built-in configuration web pages.

NOTE: 

To configure a VAV controller, enter 

the correct 

K factor

 for the VAV 

box. Typically, this is supplied by 

the manufacturer of the VAV unit. If 

this information is unavailable, use 

an approximate K factor from the 

chart in the Appendix: K Factors for 

VAV section in the 

KMC Conquest 

Controller Application Guide

.

For instructions on 

VAV balancing

:

◆

◆

With an 

STE-9000

 series NetSensor, see 

the VAV Airflow Balancing with an STE-9xx1 

section of the 

KMC Conquest Controller 

Application Guide

.

◆

◆

With a 

BAC-5051E Router

, see its 

application 

and installation guide

.

◆

◆

With 

KMC Connect

 or 

TotalControl

, see the 

Help system for the software.

SETUP PROCESS

KMC 

CONTROLS 

TOOL

Config

-

uration

Programming 

(Control Basic)

Web Page 

Graphics*

4

Conquest 

NetSensor

4

Internal con-

figuration web 

pages in Con-

quest Ethernet 

“E” models**

4

KMC Connect 

Lite

™

 (NFC) 

app***

4

4

KMC Con-

nect

™

 software

4

****

4

****

4

TotalControl

™

software

4

4

KMC Con-

verge

™

 module 

for Niagara 

WorkBench

4

KMC Con-

verge

 GFX

module for 

Niagara Work-

Bench

    *Custom graphical user-interface web pages can be 

       hosted on a remote web server, but not in the

       controller.
   **Conquest Ethernet-enabled “E” models with the 

       latest firmware can be configured with an HTML5

       compatible web browser from pages served from

       within the controller. For information, see the 

Con 

       quest Ethernet Controller Configuration Web

       Pages Application Guide

.

 ***Near Field Communication via enabled smart

       phone or tablet running the KMC Connect Lite app.

****Full configuration and programming of KMC

       Conquest controllers is supported starting with 

       TotalControl ver. 4.0.