HPO-9007 Series Gateways Installation Guide
6 923-019-05B
IMPORTANT NOTICES
NOTE:
Contains FCC ID SZV-STM300U.
902 MHz devices comply with Part 15
of the FCC Rules. Operation is subject
to the following two conditions: (i.)
these devices may not cause harmful
interference and (ii.) these devices
must accept any interference received,
including interference that may cause
undesired operation.
The material in this document is for information
purposes only. The contents and the product it
describes are subject to change without notice.
KMC Controls, Inc. makes no representations or
warranties with respect to this document. In no
event shall KMC Controls, Inc. be liable for any
damages, direct, or incidental, arising out of or
related to the use of this document.
The KMC logo is a registered trademark of KMC
Controls, Inc. All rights reserved.
TEL: 574.831.5250
FAX: 574.831.5252
© 2020 KMC Controls, Inc.
Specifications and design subject to change without notice
The sensors may also need to be
discovered again to see the icon and
EEP in the Gateway Sensor List section
of the EnOcean Sensor Port object. See
. (Restarting
the controller through software may
also cause a temporary loss of values
but should not require a new discovery
of the sensors.)
MAINTENANCE
To clean the case or display, use a soft, damp
cloth (and mild soap if necessary).
