As you can see the output channel 1 contains only the bass frequencies below
120Hz.
The settings may be copied to channel 2 using the
‚Copy Parameter’
dialogue or
setting it manually.
To operate channels 3&4 as Mid/High outputs proceed as described above but use
the
‘Low Cut’
Filter instead using the same parameters.
This setting would look like this:
As you can see the output channel 1 contains only the bass frequencies below
120Hz.
Summary of Contents for DAP 26
