EN - 13
Device-specific additional instructions for nailer
.3555
4
Filling the magazine
•
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
•
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position (Chap. 3):
The driving nose must point away from any person. It must be
impossible to unintendly actuate trigger and/or release protection.
•
Pull pusher 1 backwards and engage. Insert nail strip 2 into the
magazine from above and push forward. Disengage the pusher
and push it forward
.
5
Adjusting drive-in depth
•
Reduce pneumatic operating pressure as far as possible to
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
•
Disconnect the tool from the compressed air supply. Loosen
screw 1 on the release bracket and push release shoe 2
downwards for less recessed clamps or upwards for more
recessed clamps. Then tighten screw 1 firmly again and connect
the tool with compressed air
6
Changing the trigger setting
•
Disconnect
the unit from the compressed air supply, press button
1 on
the valve lever from behind and with the other hand set it to single
release (symbol 1 nail) or contact release (symbol with 3 nails).
Reconnect the tool to the pressure source.
7
EU Declaration of conformity
The Joh.
Friedrich
Behrens AG, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's
conformity with all relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
-------------------------------------------------
-----------------------------------------------------------
Tobias Fischer-Zernin, Management
Joachim Bauer, Documentation responsible
Summary of Contents for 12100566
Page 9: ...9 ...
